17th of April 2005

Anti-roll bars added.

Click to see big picture (1024x768 pixels, 121 KB))
1. Left front side showing arm of ARB and sliding adjuster.

Click to see big picture (640x480 pixels, 66 KB))
2. close up

Click to see big picture (480x640 pixels, 53 KB))
3. Close up of sliding mechanism and adjustable arm.

Click to see big picture (640x480 pixels, 40 KB))
4. Cut-out from nose cone.

Click to see big picture (640x480 pixels, 82 KB))
5. Where the boot box should sit.

Click to see big picture (640x480 pixels, 56 KB))
6. Rear adjusting mechanism and mounting posts.

Click to see big picture (640x480 pixels, 53 KB))
7. Other side is identical but mirror.

Click to see big picture (640x480 pixels, 59 KB))
8. Even more cramped now!

Click to see big picture (640x480 pixels, 49 KB))
9. Lower mounting system is just two L-bars that clamp the lower wishbone. I just couldn't be bothered to remove the whole lower wishbone just to weld on some brackets. This works just as well and took me 20mins to fabricate only. The silver color is basically just a protective coat of alu-zink which gives some rust protection.

Click to see big picture (640x480 pixels, 38 KB))
10. Close up

Click to see big picture (640x480 pixels, 46 KB))
11. Seen from middle of the car.