2nd of May 2004

Rollbar in place, drivers seat finalised and LCD instrumentation installed.

Click to see big picture (640x480 pixels, 50 KB))
1. Welded, painted and mounted rollbar.

Click to see big picture (640x480 pixels, 53 KB))
2. Close up of the welds.

Click to see big picture (640x480 pixels, 36 KB))
3. When welded, it shrinks in some places, meaning it doesn't fit, even though I welded most of it in place it was still off by about 8mm on this side. No big deal to use a little force to "persuade" it in place.

Click to see big picture (640x480 pixels, 74 KB))
4. Installed Mychron LCD instrumentation.

Click to see big picture (640x480 pixels, 42 KB))
5. Put the seat in place.

Click to see big picture (640x480 pixels, 75 KB))
6. Close up of the screen.

Click to see big picture (640x480 pixels, 36 KB))
7. Screen at night! It is backlit and shows very well when looking straight at it. Important to angle it properly towards the driver as night time vision is a little limited if looking from the side. The light underneath is just indicating that the generator isn't charging.


Created with Album Express on maj 16, 2004