Click to see big picture (800x600 pixels; 110 KB))
The kit arrives, here we've just unloaded the chassis and bodywork from the truck.

Click to see big picture (800x600 pixels; 120 KB))
Check it out, the tank is already in place!

Click to see big picture (800x600 pixels; 88 KB))
The aluminium panelling, pre-cut of course.

Click to see big picture (800x600 pixels; 81 KB))
Here are the boxes of stuff and the rear arches set down inside my garage on the floor.

Click to see big picture (800x600 pixels; 60 KB))
I can see some goodies in there!

Click to see big picture (800x600 pixels; 67 KB))
Uhm...more goodies. Toys for boys.

Click to see big picture (800x600 pixels; 77 KB))
Some more nice stuff. I can see some billet alu pieces in there. yummy.

Click to see big picture (800x600 pixels; 56 KB))
Here's a front spindle. Nice work. Cast and machined aluminium with induction heat treated steel spindle bolt. I like it already.

Click to see big picture (800x600 pixels; 58 KB))
Here's another view. Those straps are there to keep the washers in place so you don't mix up which one goes where.

Click to see big picture (800x600 pixels; 49 KB))
A front hub. Looks real nice.

Click to see big picture (800x600 pixels; 59 KB))
That's a steel stub shaft for the rear.

Click to see big picture (800x600 pixels; 74 KB))
Steering components

Click to see big picture (800x600 pixels; 67 KB))
That's my old and used differential with LSD I bought from a scrapyard for 1200kr.

Click to see big picture (800x600 pixels; 107 KB))
Just having a look at the chassis and the welds.

Click to see big picture (800x600 pixels; 82 KB))
More nice welds.

Click to see big picture (800x600 pixels; 116 KB))
Yep, tha

Click to see big picture (800x600 pixels; 119 KB))
Yep, that's me testing the driving position. It's actually long in the footwell. It will come in handy.

Click to see big picture (800x600 pixels; 123 KB))

Click to see big picture (800x600 pixels; 97 KB))
More nice welds.

Click to see big picture (800x600 pixels; 78 KB))
That's the fastener for the headlight assembly.

Click to see big picture (800x600 pixels; 111 KB))
Hood with air duct for EFI injection. Needed if you're using an Escort 1.8 engine with it's intake manifold that sits quite high. Even if I wasn't going with that engine, I still kinda like the way that looks.

Click to see big picture (800x600 pixels; 74 KB))
Chassis set down in the garage.


Created with Album Express on juli 19, 2003